Below are the 5 steps included in the Directions for Use of the Thermal Angel TA-200 which come packaged inside the sterile pouch.
Step 1: |
- Remove the white luer cap from the inlet end of the Thermal Angel
Insert IV line into the inlet luer
|
Step 2: |
Remove the red luer cap from the outlet end of the Thermal Angel
- Connect a standard luer IV extension set, such as TA-9EXTNF
|
Step 3: |
Prime the Thermal Angel with the infusate using normally accepted IV line priming technique.
- Ensure all air is purged from the IV line, Thermal Angel and extension set
|
Step 4: |
Connect the white end of the Power Cable into the inlet end cap of the Thermal Angel
|
Step 5: |
Connect the green end of the Power Cable into the green power cable output on the Battery.
- The green LED on the Thermal Angel should display continuous illumination. If blinking occurs refer to Troubleshooting in TA-200 Instructions for Use
|
Other Documentation is available in PDF format here.
Please see the Instructions that are packaged inside the TA-200 pouch for an Overview, Indication for Use, Operation and Set Up, Preparation, Warnings, Cautions, Troubleshooting, Symbols, Technical Specifications, Maintenance and Repairs, Warranty and Patent information.